Features July 2018 Issue

DIY Fishing Gear for Sailors

We reviewed clamp-on rod holders a few years in the past, but found them expensive (see PS October 2006). Fortunately, there are alternatives that can save hundreds of dollars and be installed in an afternoon. Less shiny, but functional.

Fishing accessories
Fishing accessories, from left: Twin holders clamped to an old outboard bracket, holder screwed into dinghy transom, the handy outrigger clip.

Simple lash-on tubes or clamp-on rocket launchers for the rail can hold anything from fishing poles, gaffs, and landing nets, to boat hooks and kayak paddles. They take less space than commercial versions, are nearly unbreakable, never scar a rail, and never slip.

Simple, non-nonsense, compact, and rugged. A 12- to 18-inch length of 1.5 to 2-inch PVC pipe lashed to the rail with 3/16-inch diameter cord holds anything from rods to boat hooks, out of the way and complete secure. The 1.5-inch-diameter will fit most rods, but not boat hooks and the like—measure first. Fit a 1.5-inch PVC cap with a ½-inch drain hole on the butt end and secure with polyurethane sealant or a screw—this will prevent longer items like boat hooks and landing nets from sliding clear through and either jamming against or scratching the deck. Mount them flush with the top rail, safely out of the way of lines. Cost: $3 including the cord.

We even added an outward-angled pair to hold stubby out-riggers (see PS September 2015). We use these only a few weeks each year for the Chesapeake Bay striped bass run, during which they allow us to trail an extra pair of lines. When not in use or docking, we slide the outriggers out and drop them into the lash-on holders next to them.

Comments (0)

Be the first to comment on this post using the section below.

New to Practical Sailor?
Register for Free!

Already Registered?
Log In